You need to modify the @ARC section of your machine template (.tmp) file. Remove the I#XCTR and J#YCTR words and use R#ARAD in their place.
================================================= Fred Lauzus, CAM Programming Coordinator High Steel Structures, Incorporated mailto:[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> http://www.highsteel.com <http://www.highsteel.com/> ================================================== -----Original Message----- From: Steve Chastain [mailto:[EMAIL PROTECTED] Sent: Tuesday, April 01, 2003 1:39 PM To: [EMAIL PROTECTED] Subject: [mfg-smartcam] Radius or I,J,K Group, Good morning, I am almost ashamed to even ask this but can someone please tell where to indicate whether or not to use "R" value or I's and J's for arc radii. I thought it was just a yes or no in the machine define but I can't seem to find it. That is one of the things about smartcam, once you get things set and tweaked in you never have to change them. So in short I have forgotten where a lot of these things are. Thanks in advance Steve Chastain Viper Northwest Phn: 541-928-2529 Fax: 541-928-1526 ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
