All the values you need for either format are output at all times. You use the ones you want in the ARC section of your .tmp file.
This is an example using R for angles below 360 degrees, and I,J for other angles.
@ARC
< #MOV>< #PLANE>< X#XPOS>< Y#YPOS>#EXLN
#IF(ABS(#TANG)<360)< R#ARAD>#ELSE<< I#XCTR>< J#YCTR>>< F#FEED>
Gene Bowen
Steve Chastain wrote:
Group,
Good morning, I am almost ashamed to even ask this but can someone please tell where to indicate whether or not to use “R” value or I’s and J’s for arc radii. I thought it was just a yes or no in the machine define but I can’t seem to find it. That is one of the things about smartcam, once you get things set and tweaked in you never have to change them. So in short I have forgotten where a lot of these things are. Thanks in advance
Steve Chastain
Viper Northwest
Phn: 541-928-2529
Fax: 541-928-1526
