Hey all, I recently made a slightly moronic mistake. I accidentally saved-over an important .pm4 file. I do not have a back-up of this file. The .jof is fine and the .cod(code file) is still intact and dialed in perfectly, so I can still run the parts on the cnc. The part is a little complicated, and me being lazy, I don't want to have to redraw the part. My question: is there someway to convert the .jof and the .cod into a .pm4. I prefer not to redraw the part because it was drawn about 5 years ago, and I am not exactly sure how I drew it, but the parts yield and cut perfectly. Any suggestions? Thanks.
Joe Medeiros Precision Plastics Sacramento, CA 916-689-5284 ________________________________________________________________ The best thing to hit the internet in years - Juno SpeedBand! Surf the web up to FIVE TIMES FASTER! Only $14.95/ month - visit www.juno.com to sign up today! ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
