Hello, I am in the process of replacing the head in my 97 with a rebuilt one from cylinder-heads.com . old head was running way to much oil through valve guides. any ways we have all but one piece switched over from old to rebuilt one. There is a little water outlet on the back of the head next to the main water outlet.
Can any one give me some suggestions on how to remove it? and possibly to install it in the newer head? we have tried heating it and cooling it, but the material transfers heat/cold to fast to work it seems (even with torch on head and dry ice on the tube) suggestion from cylinder-heads.com is to tap it back and forth with a hammer and use vice grips to twist/pull it. I have not tried this just yet (head is in a friends garage right now) here are a few pictures to show what i am talking about. *old head*: http://www.flickr.com/photos/[EMAIL PROTECTED]/2406194237/ *new head*: http://www.flickr.com/photos/[EMAIL PROTECTED]/2406194283/ Thanks _______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
