---- [EMAIL PROTECTED] wrote: 
> 
> You're assuming that the radio waves must be broadcast, that the  frequencies 
> must be what they are today, 

I used VHF broadcast as an example because FM and VHF television stations are 
the second most powerful form of RF emission to be found in North America. UHF 
television stations are the most powerful, with Equivalent Radiated Power 
ratings in the 1 to 4 megawatt class, however even these must comply with 
exposure guidelines, and their output power is being reduced as stations turn 
off their analog carriers and go fully digital. Other sources of RF energy such 
as cellular towers, satellites, 2-way radio and the like are many orders of 
magnitude lower in strength. 

Additionally, the trend over the past 30 to 40 years in general has been 
towards decreasing the output power of all transmitters in general, as RF 
"pollution" (ie: interfereance) becomes a problem, receivers become more 
sensitive and selective, and the transition towards digital modulation 
increases the tolerance of receivers to noise and allows them to recover useful 
signals at much lower input amplitudes than an analog system. 

So it really doesn't matter what the source is or what the frequency is- 
ambient RF is simply too weak to drive a toy car, much less a real one. It's 
not a matter of advanced technology, there simply isn't enough energy floating 
around in the form of RF to do any useful work to begin with. 


> ... and that the waves would be the primary  source 
> of "power" or "fuel" for the vehicle.  As mentioned several times,  if the 
> waves were used to power/generate light, the light could power  photovoltaic 
> cells to produce electricity.

You're joking, right? Putting aside everything we know about the state of 
modern technology, it's a basic law of physics that you cannot get more power 
out of a system then you put into it. By taking RF energy, rectifying it, using 
it to drive a light bulb, pointing the light bulb at a photovoltaic cell, and 
then using the electricity coming out the other end you will get far less power 
out of the system than if you'd used the energy that drove the light bulb 
directly. Even if we are using magical light bulbs and photovoltaic cells that 
are 100% efficient, the power coming out the back will only be equal to the 
power going in the front, which is simply too miniscule to be of any use in the 
first place. 

Let's take a very simple example. You connect an AC motor directly to an AC 
generator. Don't laugh, these do exist- they're called rotary phase converters. 
Now, you plug the motor into an outlet, you apply a load to the output of the 
generator, and you measure the work being done. No matter what you do, no 
matter how efficient everything is, the amount of electricity coming out of the 
generator will never be greater than the amount of electricity going into the 
motor. You can wind the generator to produce a higher voltage than the motor is 
getting, however the output current will be reduced by an equal factor. 
Likewise you can wind for higher current, at reduced voltage. You can change 
the phase, you can do all sorts of useful things, but you cannot get more 
actual power out than you put in. Same as if you shone a light bulb at a solar 
cell, or pointed an electric fan at a windmill, or any other wild fantasy 
scenario you can come up with. 


> As a Radio Engineer, you're aware of the progression in electronics  
> capbilities today from that of only 40 years ago.  What may not seem  
> possible today is only development-time away. 

Yes, I am. IC semiconductor technology, DSPs, fiberoptic transmission, 
satellite carriers, COFDM, all wonderful things which were probably 
unimaginable to Farnsworth and Sarnoff. However none of these things violate 
the First Law of Thermodynamics regarding conservation of energy in a closed 
system, a basic tenet which has gone pretty much unchanged since Thales of 
Miletus started pondering the nature of water in the mid 500s BC. 


Please, just stop embarrassing yourself now. 
_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to