Verify the travel *before* you start throwing parts. If the travel at
the slave is ok, the master is good.
 

Bill Cardell 
TurboDog's Dad 
www.flyinmiata.com 
www.fmwestfield.com 
Sales 1-800-359-6957 
Tech 970-464-5600 Before you call, check out
http://www.flyinmiata.com/FAQ/ 

 

________________________________

From: Eric McCord [mailto:[email protected]] 
Sent: Wednesday, March 24, 2010 6:37 PM
To: Luis
Cc: Ray; Bill Cardell; [email protected]
Subject: Re: Clutch not fully releasing...ACT 1.8 Happy Meal setup...


Gonna give that a shot next......already have the new Master Cylinder..

After that then OUT comes the trans...

Eric


On Wed, Mar 24, 2010 at 8:31 PM, Luis <[email protected]> wrote:


        Wait! Hold the phone! Don't pull the tranny yet!

         

        Couldn't this be a simple clutch master cylinder failure?

         

         

         

        Luis

         

        
________________________________


        From: [email protected]
[mailto:[email protected]] On Behalf Of atomicarlton
        Sent: Wednesday, March 24, 2010 7:51 PM
        To: Ray; atomicarlton; Bill Cardell; [email protected] 

        Subject: RE: Clutch not fully releasing...ACT 1.8 Happy Meal
setup...

        

         

        Ray,
        
        I just reused the pilot bearing that was in there when I did the
tranny swap last year. If you recall, I was in a hurry to give my wife a
reason to drop me on my ass......
        
        I am preparing myself for another tranny pull.
        
        Eric

        
________________________________


        From: Ray <[email protected]>
        Sent: Wednesday, March 24, 2010 7:34 PM
        To: atomicarlton <[email protected]>; Bill Cardell
<[email protected]>; [email protected]
        Subject: Re: Clutch not fully releasing...ACT 1.8 Happy Meal
setup...

        Did you remember to replace the pilot bearing last year?

                ----- Original Message -----

                From: atomicarlton <mailto:[email protected]> 

                To: Bill Cardell <mailto:[email protected]>  ;
atomicarlton <mailto:[email protected]>  ;
[email protected]

                Sent: Wednesday, March 24, 2010 11:27 AM

                Subject: RE: Clutch not fully releasing...ACT 1.8 Happy
Meal setup...

                 

                I will try redoing the adjustments.....I was hoping too
not drop the trans AGAIN....had all my fun doing that last year. :-)
                
                Eric

                
________________________________


                From: Bill Cardell <[email protected]>

        
        
        [The entire original message is not included]


        _______________________________________________
        Miatapower mailing list
        [email protected]
        http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
        
        


_______________________________________________
Miatapower mailing list
[email protected]
http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower

Reply via email to