This is Raspberry Pi 4 running current/arm64
(dmesg below, inside a full cereal log).

Right after the boot sequence finishes and filesystems are mounted,
some of the daemons being started are getting killed, syslogd among
them, there is nothing in /var/log/messages, but see what ntpd -d and
smtpd -ddd themselves say when trying to start.

Where do I start looking? Is that a HW fault?
I did a full sysupgrade -sf, which went fine,
but the problem persists.

        Thank you

                Jan



U-Boot 2025.07 (Oct 06 2025 - 07:00:47 -0600)

DRAM:  948 MiB (total 7.9 GiB)
RPI 4 Model B (0xd03114)
Core:  213 devices, 16 uclasses, devicetree: board
MMC:   mmcnr@7e300000: 1, mmc@7e340000: 0
Loading Environment from FAT... Unable to read "uboot.env" from mmc0:1...
In:    serial,usbkbd
Out:   serial,vidconsole
Err:   serial,vidconsole
Net:   eth0: ethernet@7d580000
?25h
PCIe BRCM: link up, 5.0 Gbps x1 (SSC)
starting USB...
Register 5000420 NbrPorts 5
Starting the controller
USB XHCI 1.00
Bus xhci_pci: 2 USB Device(s) found
       scanning usb for storage devices... 0 Storage Device(s) found
r999;999H6nCardsdid notorespond0to voltage select! : -110
Cannot persist EFI variables without system partition
** Booting bootflow '<NULL>' with efi_mgr
Booting: Label: mmc 0 Device path: 
/VenHw(e61d73b9-a384-4acc-aeab-82e828f3628b,0000000000000000)/VenHw(e61d73b9-a384-4acc-aeab-82e828f3628b,6d00000005000000)/SD(0)/SD(1)
disks: sd0*
>> OpenBSD/arm64 BOOTAA64 1.22
boot>
booting sd0a:/bsd: 
12581896+2941272+324032+869904\[1059682+91+1383984+877516]=0x144e898
[ using 3322056 bytes of bsd ELF symbol table ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
        The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2025 OpenBSD. All rights reserved.  https://www.OpenBSD.org

OpenBSD 7.8-current (GENERIC.MP) #97: Thu Dec 18 16:30:51 MST 2025
    [email protected]:/usr/src/sys/arch/arm64/compile/GENERIC.MP
real mem  = 8441495552 (8050MB)
avail mem = 8139554816 (7762MB)
random: good seed from bootblocks
mainbus0 at root: Raspberry Pi 4 Model B Rev 1.4
efi0 at mainbus0: UEFI 2.11
efi0: Das U-Boot rev 0x20250700
smbios0 at efi0: SMBIOS 3.7.0
smbios0: vendor U-Boot version "2025.07" date 07/01/2025
smbios0: raspberrypi Raspberry Pi 4 Model B Rev 1.4
cpu0 at mainbus0 mpidr 0: ARM Cortex-A72 r0p3
cpu0: 48KB 64b/line 3-way L1 PIPT I-cache, 32KB 64b/line 2-way L1 D-cache
cpu0: 1024KB 64b/line 16-way L2 cache
cpu0: CRC32,ASID16
cpu1 at mainbus0 mpidr 1: ARM Cortex-A72 r0p3
cpu1: 48KB 64b/line 3-way L1 PIPT I-cache, 32KB 64b/line 2-way L1 D-cache
cpu1: 1024KB 64b/line 16-way L2 cache
cpu2 at mainbus0 mpidr 2: ARM Cortex-A72 r0p3
cpu2: 48KB 64b/line 3-way L1 PIPT I-cache, 32KB 64b/line 2-way L1 D-cache
cpu2: 1024KB 64b/line 16-way L2 cache
cpu3 at mainbus0 mpidr 3: ARM Cortex-A72 r0p3
cpu3: 48KB 64b/line 3-way L1 PIPT I-cache, 32KB 64b/line 2-way L1 D-cache
cpu3: 1024KB 64b/line 16-way L2 cache
"linux,cma" at mainbus0 not configured
"nvram" at mainbus0 not configured
apm0 at mainbus0
"system" at mainbus0 not configured
"axi" at mainbus0 not configured
simplebus0 at mainbus0: "soc"
bcmclock0 at simplebus0
bcmmbox0 at simplebus0
bcmgpio0 at simplebus0
bcmaux0 at simplebus0
ampintc0 at simplebus0 nirq 256, ncpu 4 ipi 0: "interrupt-controller"
bcmtmon0 at simplebus0
bcmdmac0 at simplebus0: DMA0 DMA2 DMA4 DMA5 DMA6 DMA7 DMA8 DMA9 DMA10
pluart0 at simplebus0: rev 3, 32 byte fifo
pluart0: console
"interrupt-controller" at simplebus0 not configured
bcmdog0 at simplebus0
bcmirng0 at simplebus0
"firmware" at simplebus0 not configured
"power" at simplebus0 not configured
"mailbox" at simplebus0 not configured
sdhc0 at simplebus0
sdhc0: SDHC 3.00, 250 MHz base clock
sdmmc0 at sdhc0: 4-bit, sd high-speed, mmc high-speed
"gpiomem" at simplebus0 not configured
"fb" at simplebus0 not configured
simplebus1 at simplebus0: "nvmem"
"nvmem_otp" at simplebus1 not configured
"nvmem_cust" at simplebus1 not configured
"nvmem_priv" at simplebus1 not configured
simplebus2 at mainbus0: "clocks"
"clk-osc" at simplebus2 not configured
"clk-usb" at simplebus2 not configured
"phy" at mainbus0 not configured
"clk-27M" at mainbus0 not configured
"clk-108M" at mainbus0 not configured
simplebus3 at mainbus0: "emmc2bus"
sdhc1 at simplebus3
sdhc1: SDHC 3.00, 100 MHz base clock
sdmmc1 at sdhc1: 8-bit, sd high-speed, mmc high-speed, ddr52, dma
"pmu" at mainbus0 not configured
agtimer0 at mainbus0: 54000 kHz
simplebus4 at mainbus0: "scb"
bcmpcie0 at simplebus4
pci0 at bcmpcie0
ppb0 at pci0 dev 0 function 0 "Broadcom BCM2711" rev 0x10
pci1 at ppb0 bus 1
xhci0 at pci1 dev 0 function 0 "VIA VL805 xHCI" rev 0x01: intx, xHCI 1.0
usb0 at xhci0: USB revision 3.0
uhub0 at usb0 configuration 1 interface 0 "VIA xHCI root hub" rev 3.00/1.00 
addr 1
bse0 at simplebus4: address dc:a6:32:e0:50:d3
brgphy0 at bse0 phy 1: BCM54210E, rev. 2
"codec" at simplebus4 not configured
"dma" at simplebus4 not configured
gpioleds0 at mainbus0: "ACT", "PWR"
"cam_dummy_reg" at mainbus0 not configured
"regulator-cam1" at mainbus0 not configured
"regulator-sd-io-1v8" at mainbus0 not configured
"regulator-sd-vcc" at mainbus0 not configured
"fixedregulator_3v3" at mainbus0 not configured
"fixedregulator_5v0" at mainbus0 not configured
"zone_dma" at mainbus0 not configured
simplebus5 at mainbus0: "v3dbus"
scsibus0 at sdmmc1: 2 targets, initiator 0
sd0 at scsibus0 targ 1 lun 0: <Sandisk, SE32G, 0080> removable
sd0: 30436MB, 512 bytes/sector, 62333952 sectors
uhub1 at uhub0 port 1 configuration 1 interface 0 "VIA Labs USB2.0 Hub" rev 
2.10/4.21 addr 2
bwfm0 at sdmmc0 function 1
manufacturer 0x02d0, product 0xa9a6 at sdmmc0 function 2 not configured
manufacturer 0x02d0, product 0xa9a6 at sdmmc0 function 3 not configured
vscsi0 at root
scsibus1 at vscsi0: 256 targets
softraid0 at root
scsibus2 at softraid0: 256 targets
root on sd0a (a33fd4503d85af46.a) swap on sd0b dump on sd0b
WARNING: CHECK AND RESET THE DATE!
gpio0 at bcmgpio0: 58 pins
bwfm0: address dc:a6:32:e0:50:d4
Automatic boot in progress: starting file system checks.
/dev/sd0a (a33fd4503d85af46.a): file system is clean; not checking
/dev/sd0f (a33fd4503d85af46.f): file system is clean; not checking
/dev/sd0g (a33fd4503d85af46.g): file system is clean; not checking
/dev/sd0h (a33fd4503d85af46.h): file system is clean; not checking
/dev/sd0d (a33fd4503d85af46.d): file system is clean; not checking
/dev/sd0e (a33fd4503d85af46.e): file system is clean; not checking
/dev/sd0n (a33fd4503d85af46.n): file system is clean; not checking
/dev/sd0m (a33fd4503d85af46.m): file system is clean; not checking
Killed
pf enabled
net.inet.ip.forwarding: 0 -> 1
net.inet.ip.mforwarding: 0 -> 1
net.inet.ip.multipath: 0 -> 1
starting network
starting early daemons: syslogd pflogd ntpd.
starting RPC daemons:.
savecore: /dev/sd0b: Device not configured
checking quotas: done.
clearing /tmp
kern.securelevel: 0 -> 1
creating runtime link editor directory cache.
preserving editor files.
starting network daemons: sshd smtpd.
starting local daemons: cron.
Fri Dec 19 02:16:04 CET 2025

OpenBSD/arm64 (rpi.stare.cz) (console)

login: root
Password:
Last login: Fri Dec 19 01:06:12 on console
OpenBSD 7.8-current (GENERIC.MP) #97: Thu Dec 18 16:30:51 MST 2025

Welcome to OpenBSD: The proactively secure Unix-like operating system.

Please use the sendbug(1) utility to report bugs in the system.
Before reporting a bug, please try to reproduce it with the latest
version of the code.  With bug reports, please try to ensure that
enough information to reproduce the problem is enclosed, and if a
known fix for it exists, include that as well.

rpi# rcctl ls failed
ntpd
resolvd
slaacd
smtpd
syslogd
rpi# m
rpi#
rpi#

rpi# ping www.openbsd.org
PING www.openbsd.org (199.185.178.80): 56 data bytes
64 bytes from 199.185.178.80: icmp_seq=0 ttl=235 time=139.550 ms
64 bytes from 199.185.178.80: icmp_seq=1 ttl=235 time=139.509 ms
64 bytes from 199.185.178.80: icmp_seq=2 ttl=235 time=139.472 ms
^C
--- www.openbsd.org ping statistics ---
3 packets transmitted, 3 packets received, 0.0% packet loss
round-trip min/avg/max/std-dev = 139.472/139.510/139.550/0.032 ms

rpi# rcctl restart ntpd
ntpd(failed)
rpi# rcctl restart ntpd
ntpd(failed)
rpi# ntpd -ddd
/var/db/ntpd.drift is empty
ntp engine ready
constraint 142.251.141.164; terminated with signal 9 (Killed)
constraint reply from 9.9.9.9: offset 288137.990503
constraint reply from 77.75.79.222: offset 288137.937557
constraint reply from 77.75.77.222: offset 288137.937298

smtpd(ok)

rpi# rcctl ls failed
ntpd
resolvd
slaacd
smtpd
syslogd

rpi# smtpd -ddd
info: OpenSMTPD 7.8.0 starting
smtpd: imsg_wait: Bad address
control: imsg_wait: No such file or directory
rpi# lookup: imsg_wait: No such file or directory
scheduler: imsg_wait: No such file or directory
queue: imsg_wait: No such file or directory

Reply via email to