Hi,
I bought one of these and tried to install openbsd on it.
My first try was with 4.3 bsd booting over PXE.
As the ethernet wasn't recognized by the kernel I installed using a
usb thumb drive because I hadn't found how to boot from a usb device
at this moment.
Although the kernel claimed to recognize the atheros wireless card, I
couldn't use it (ath%d: ath_chan_set: unable to reset channel %u (%u
Mhz)).
Now I'm trying to boot bsd from a snapshot (as of yesterday 21:00
GMT+2) but the kernel hang on the sata driver apparently
pciide0 at pci0 dev 31 function 2 "Intel 82801FBM SATA" rev 0x04: DMA,
channel 0 wired to compatibility, channel 1 wired to compatibility).
Surprisingly, I tried and successfully booted bsd.mp a few times, but
it sometimes hang a little further on
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16.
And sometimes it inverts the SDCard slot and the usb disk so it's
kinda difficult to get a properly running box yet to test.
I tried with bsd.rd and was able to install a working system and
again, booting bsd ain't working and bsd.mp often hangs on npx0 and
sometimes(rarely) boots successfully.
Here's a dmesg:
OpenBSD 4.3-current (GENERIC.MP) #776: Sun Jun 29 11:34:39 MDT 2008
[EMAIL PROTECTED]:/usr/src/sys/arch/i386/compile/GENERIC.MP
cpu0: Intel(R) Celeron(R) M processor 900MHz ("GenuineIntel" 686-class) 901 MHz
cpu0:
FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,CFLUSH,DS,ACPI,MMX,FXSR,SSE,SSE2,SS,TM,SBF
real mem = 1064398848 (1015MB)
avail mem = 1020956672 (973MB)
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 05/12/08, BIOS32 rev. 0 @
0xf0010, SMBIOS rev. 2.5 @ 0xf06f0 (37 entries)
bios0: vendor American Megatrends Inc. version "0501" date 05/12/2008
bios0: ASUSTeK Computer INC. 900
apm0 at bios0: Power Management spec V1.2
apm0: AC on, battery charge unknown
acpi at bios0 function 0x0 not configured
pcibios0 at bios0: rev 3.0 @ 0xf0000/0x10000
pcibios0: PCI IRQ Routing Table rev 1.0 @ 0xf7410/176 (9 entries)
pcibios0: PCI Interrupt Router at 000:31:0 ("Intel 82801FB LPC" rev 0x00)
pcibios0: PCI bus #5 is the last bus
bios0: ROM list: 0xc0000/0xf800!
mainbus0: Intel MP Specification (Version 1.4)
cpu0 at mainbus0: apid 0 (boot processor)
cpu0: apic clock running at 100MHz
mainbus0: bus 0 is type PCI
mainbus0: bus 1 is type PCI
mainbus0: bus 2 is type PCI
mainbus0: bus 3 is type PCI
mainbus0: bus 4 is type PCI
mainbus0: bus 5 is type PCI
mainbus0: bus 6 is type ISA
ioapic0 at mainbus0: apid 1 pa 0xfec00000, version 20, 24 pins
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "Intel 82915GM Host" rev 0x04
vga1 at pci0 dev 2 function 0 "Intel 82915GM Video" rev 0x04
wsdisplay0 at vga1 mux 1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
agp0 at vga1: aperture at 0xd0000000, size 0x10000000
"Intel 82915GM Video" rev 0x04 at pci0 dev 2 function 1 not configured
azalia0 at pci0 dev 27 function 0 "Intel 82801FB HD Audio" rev 0x04:
apic 1 int 16 (irq 5)
azalia0: codec[s]: Realtek/0x0662
audio0 at azalia0
ppb0 at pci0 dev 28 function 0 "Intel 82801FB PCIE" rev 0x04: apic 1
int 16 (irq 5)
pci_intr_map: bus 0 dev 28 func 0 pin 4; line 3
pci_intr_map: no MP mapping found
pci1 at ppb0 bus 4
ppb1 at pci0 dev 28 function 1 "Intel 82801FB PCIE" rev 0x04: apic 1
int 17 (irq 11)
pci_intr_map: bus 0 dev 28 func 1 pin 4; line 3
pci_intr_map: no MP mapping found
pci2 at ppb1 bus 3
lii0 at pci2 dev 0 function 0 "Attansic Technology L2" rev 0xa0: apic
1 int 17 (irq 11), address 00:1f:c6:8f:0d:ee
ukphy0 at lii0 phy 1: Generic IEEE 802.3u media interface, rev. 2: OUI
0x001374, model 0x0002
ppb2 at pci0 dev 28 function 2 "Intel 82801FB PCIE" rev 0x04: apic 1
int 18 (irq 10)
pci_intr_map: bus 0 dev 28 func 2 pin 4; line 3
pci_intr_map: no MP mapping found
pci3 at ppb2 bus 1
ath0 at pci3 dev 0 function 0 "Atheros AR5424" rev 0x01: apic 1 int 18 (irq 10)
ath0: AR5424 14.2 phy 7.0 rf 0.0, WOR0W, address 00:15:af:a7:3d:55
uhci0 at pci0 dev 29 function 0 "Intel 82801FB USB" rev 0x04: apic 1
int 23 (irq 7)
uhci1 at pci0 dev 29 function 1 "Intel 82801FB USB" rev 0x04: apic 1
int 19 (irq 3)
uhci2 at pci0 dev 29 function 2 "Intel 82801FB USB" rev 0x04: apic 1
int 18 (irq 10)
uhci3 at pci0 dev 29 function 3 "Intel 82801FB USB" rev 0x04: apic 1
int 16 (irq 5)
ppb3 at pci0 dev 30 function 0 "Intel 82801BAM Hub-to-PCI" rev 0xd4
pci_intr_map: bus 0 dev 30 func 0 pin 1; line 11
pci_intr_map: no MP mapping found
pci_intr_map: bus 0 dev 30 func 0 pin 2; line 3
pci_intr_map: no MP mapping found
pci4 at ppb3 bus 5
ichpcib0 at pci0 dev 31 function 0 "Intel 82801FBM LPC" rev 0x04: PM disabled
pciide0 at pci0 dev 31 function 2 "Intel 82801FBM SATA" rev 0x04: DMA,
channel 0 wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 1 drive 0: <ASUS-PHISON OB SSD>
wd0: 1-sector PIO, LBA, 3847MB, 7880544 sectors
wd1 at pciide0 channel 1 drive 1: <ASUS-PHISON SSD>
wd1: 1-sector PIO, LBA, 7695MB, 15761088 sectors
wd0(pciide0:1:0): using PIO mode 4, Ultra-DMA mode 4
wd1(pciide0:1:1): using PIO mode 4, Ultra-DMA mode 4
ichiic0 at pci0 dev 31 function 3 "Intel 82801FB SMBus" rev 0x04: apic
1 int 19 (irq 0)
iic0 at ichiic0
spdmem0 at iic0 addr 0x50: 1GB DDR2 SDRAM non-parity PC2-3200CL5 SO-DIMM
usb0 at uhci0: USB revision 1.0
uhub0 at usb0 "Intel UHCI root hub" rev 1.00/1.00 addr 1
usb1 at uhci1: USB revision 1.0
uhub1 at usb1 "Intel UHCI root hub" rev 1.00/1.00 addr 1
usb2 at uhci2: USB revision 1.0
uhub2 at usb2 "Intel UHCI root hub" rev 1.00/1.00 addr 1
usb3 at uhci3: USB revision 1.0
uhub3 at usb3 "Intel UHCI root hub" rev 1.00/1.00 addr 1
isa0 at ichpcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pmsi0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pmsi0 mux 0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
spkr0 at pcppi0
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
mtrr: Pentium Pro MTRR support
umass0 at uhub1 port 2 configuration 1 interface 0 "SMI Corporation
USB DISK" rev 2.00/11.00 addr 2
umass0: using SCSI over Bulk-Only
scsibus0 at umass0: 2 targets, initiator 0
sd0 at scsibus0 targ 1 lun 0: <USB, Flash Disk, 1100> SCSI0 0/direct removable
sd0: 956MB, 121 cyl, 255 head, 63 sec, 512 bytes/sec, 1957888 sec total
umass1 at uhub2 port 1 configuration 1 interface 0 "ENE UB6225" rev
2.00/1.00 addr 2
umass1: using SCSI over Bulk-Only
scsibus1 at umass1: 2 targets, initiator 0
sd1 at scsibus1 targ 1 lun 0: <USB2.0, CardReader SD0, 0100> SCSI0
0/direct removable
sd1: drive offline
uvideo0 at uhub3 port 2 configuration 1 interface 0 "Chicony
Electronics Co., Ltd. CNF7129" rev 2.00/15.12 addr 2
video0 at uvideo0
softraid0 at root
root on sd0a swap on sd0b dump on sd0b
