Try checking the wiring to the ECU connector, sometimes the actual connector
that plug at the ECU get corroded, dirty, making a false contact.

good luck

Francesco.


----------------------------------------------------------
DIFUNDE NUESTRA PAGINA WEB
http://www.geocities.com/fontaracing
----- Original Message -----
From: "Anthony Pelletier" <[email protected]>
To: "Patrick Austin" <[email protected]>; <[email protected]>;
<[email protected]>
Sent: Wednesday, August 22, 2001 7:03 AM
Subject: Re: Running problems again: Still running badly.


> It still could be something with the 02 wireing.  The
> 02 is the sensor and the dpr is the actor.  BTW what
> is the air mass sensor?  Is that on the other side of
> the fuel dist that measures the air flow plate?
>
>
>
> --- Patrick Austin <[email protected]> wrote:
> > Okay...
> >
> > a) DPR plugged in, O2 sensor disconnected: Car
> > hesitates badly, won't drive.
> > b) DPR pluged in, O2 sensor connected, Air Mass
> > Sensor disconnected:  Car
> > hesitates badly, won't drive.
> > c) DPR unplugged, O2 sensor plugged in, Air Mass
> > sensor plugged in:  Car
> > doesn't hesitate, pulls to redline.
> >
> > So, if the O2 sensor were the culprit, I'd expect
> > the car to run OK in
> > scenario a).  Were it the air sensor, I'd expect it
> > to run OK in scenario
> > b).  As it is, it only runs OK in scenario c).  Were
> > the transfer pump bad,
> > I'd expect the car to run just as badly with and
> > without the DPR plugged
> > in.  WTF???  Could it be the TT chip I installed a
> > couple of days ago?  It
> > ran fine just after I installed it, but maybe it's
> > 'learning' a bad habit.
> > The air intake boot seems fine, as do the major
> > vacuum lines.
> >
> > At 04:34 PM 8/19/01 EDT, [email protected] wrote:
> > >In a message dated 8/18/01 9:19:01 PM US Eastern
> > Standard Time,
> > [email protected]
> > >writes:
> > >
> > >
> > > If the
> > > What
> > >exactly does the DPR do, and why does it run fine
> > without it hooked up?
> > >
> > >
> > >The DPR is controlled by the o2 sensor, and it
> > riches/leans the mixture
> > based
> > > Plug the DPR back in, and disconnect the o2
> > > Let us know what happens.
> > >
> > >-Dave
> > >'91 Jetta GTX 16V
> > >'88 Jetta GLI 16V
> > >'84 Vanagon
> > **************
> > Patrick Austin
> > [email protected]
> > (617)782-9115
> > **************
> > _____________
> > List Sponsor: http://www.netsville.com
> > To remove yourself from this list, send mail to
> > [email protected] with 'unsubscribe a2_16v' in
> > the body of your message
> > See us on the web at http://www.a2-16v.com
> > Visit the 16V Homepage at http://www.gti16v.org
>
>
> __________________________________________________
> Do You Yahoo!?
> Make international calls for as low as $.04/minute with Yahoo! Messenger
> http://phonecard.yahoo.com/

_____________
List Sponsor: http://www.netsville.com
To remove yourself from this list, send mail to [email protected] with 
'unsubscribe a2_16v' in the body of your message
See us on the web at http://www.a2-16v.com
Visit the 16V Homepage at http://www.gti16v.org

Reply via email to