Mark Styles wrote:
> On Sun, Jul 11, 2010 at 02:17:05PM -0400, Hroðgar Skjöldung wrote:
> Good to know it's not a lost cause at least.
Did you build yours from source or did you use a deb or prebuild and
what version is it ?
>> If you get any errors please post them, I will help if I can
>
> I don't get errors, but if I run it with -D I get:
>
> Unit:
> ID: 0
> Version: 0.00RX (intr) [-110]:(CMDDAT Abort)
> RX (intr) [-110]:(CMDDAT Abort)
> RX (intr) [-110]:(CMDDAT Abort)
What's your full command line? I made a mistake with the "usb:" see
below. With debug enabled, I dont get these messages. But I do get
stuff like << [ERROR] GPS_Packet_Read: Timeout. No data received.>>
However, the data does eventually all get transfered.
Just to cover some basics before going too far. Do you have read
permissions on the Garmin tty? It looks like you do but for safeties sake.
# confirm the location of the garmin
dmesg | grep Garmin
#
ls -l /dev/ttyUSB?
This just worked for me, my garmin is assigned to /dev/ttyUSB1
gpsbabel-1.4.1/gpsbabel -D 2 -r -t -w -i garmin -f /dev/ttyUSB1 -o gpx
-F output.gpx
NB: When I wrote "usb:" that works for MacOS and apparently on linux
but I realize that I have never used that on linux :)
Ciao
Hroth
_______________________________________________
mlug mailing list
[email protected]
https://listes.koumbit.net/cgi-bin/mailman/listinfo/mlug-listserv.mlug.ca
