* This is the modus mailing list * If you are getting a yellow alarm on your end that means that something on the line, probably the other side if this is a point to point circuit is producing a red alarm locally and sending a yellow alarm. The red alarm means the CSU is not seeing a signal. I would check the connections and port on your end. If the second port of the 2501 is open try switching to that.
I have seen 2500's go bad after years of service. Gary > * This is the modus mailing list * > > We are having some problems with latency on our T1 and looking for some > ideas on where to dig further. MCI/Verizon provide the circuit and they say > the line is clean. We use a Cisco 2501 and Kentrex D-Serv CSU/DSU. We're > getting dropped packets and on the CSU/DSU the "Far end" light occasionally > blinks yellow at the same time as the T1 "green" light goes off. MCI tech > suspects the router or the cable between the Kentrex and the Cisco. I doubt > it's the cable and I've power cycled everything and reseated the cables. > When MCI loops to the smart jack or the Kentrex they get a clean circuit > (tested each for twenty minutes), but when they go to the router they get > packet loss. > > Time for a new router (purchased in 1996)? Any other things to try? > > If you've got some ideas, please reply off-list. > > Thanks! > > John > > > ** > To unsubscribe, send an Email to: [EMAIL PROTECTED] > with the word "UNSUBSCRIBE" in the body or subject line. > ** To unsubscribe, send an Email to: [EMAIL PROTECTED] with the word "UNSUBSCRIBE" in the body or subject line.
