I just did some further test on rrdtool libtool .... and found that I can not yet include it into the main edition, for the reasons listed below ... I will release 1.0.4 in a few minutes, with all the updates I made since 1.0.3 so that any libtool gurus out there can have a shot at it ...
I will not be makeing many changes to rrdtool in the comming weeks as I am working on MRTG-3 ... so this is the ideal time to add proper libtool support ... with dist, install and all ... Just one thing: * I would prefere if building static libraries remained the default building rrdtool with a dynamic lib should be enabled with ./configure --with-shared=yes or the like ... cheers tobi *> *> 1) Made sure all the RRdtool pieces get installed in the correct place *> with a make install. *> 2) Added all files to the Makefile.am's such that a make dist can *> be performed to create a RRDtool distribution. *> 3) docs/Makefile has not been touched. This could also probably be *> automake'd. *> 4) I have not figured out how to put perl-shared and perl-piped *> inside the automake structure nicely, but it works. Look at the *> top level Makefile.am to see how I do it. *> *> Since this work has a lot of changes, I'm just leaving the new tar file *> up at *> *> ftp://ftp.gps.caltech.edu/pub/blair/rrdtool-1.0.3a.tar.gz *> *> The diffs between this and pure 1.0.3 are 165 k in size. *> *> If you do any developing on this, please make sure to download and *> install the latest autoconf (2.13), automake (1.4), and libtool *> (1.3.3) from ftp.gnu.org. *> *> Good luck, *> Blair -- ______ __ _ /_ __/_ / / (_) Oetiker, Timelord & SysMgr @ EE-Dept ETH-Zurich / // _ \/ _ \/ / TEL: +41(0)1-6325286 FAX:...1517 ICQ: 10419518 /_/ \.__/_.__/_/ [EMAIL PROTECTED] http://ee-staff.ethz.ch/~oetiker -- Binary/unsupported file stripped by Listar -- -- Type: TEXT/X-VCARD -- File: bzajac.vcf -- Desc: Card for Blair Zajac -- * To unsubscribe from the rrd-developers mailing list, send a message with the subject: unsubscribe to [EMAIL PROTECTED]
