The crucial line is WARNING: Skipping host fcswitch as it does not resolve to an IPv4 address
Make sure that the name you put in your config file is the right name for the device; if you can't ping it by that name, MRTG can't do anything as far as monitoring it. Matt ----- Original Message ---- From: anjini shukla <[EMAIL PROTECTED]> To: [email protected] Sent: Tuesday, August 26, 2008 4:56:12 PM Subject: [mrtg] MRTG Brocade switch monitoring error Hello, I am trying to plot graphs for my Brocade 4100 SAN switch and am using Solaris 10, I am following the documentation given: http://www.xolution.ch/mrtg/ i have written my config file: ~ snip Target[switch.IP_0]: 1.3.6.1.4.1.1588.2.1.1.1.6.2.1.12.1&1.3.6.1.4.1.1588.2.1.1.1.6.2.1.11.1:[EMAIL PROTECTED] Title[switch.IP_0]: fc throughput on switch fcswitch port 0 (mysun jnic0 slot7) PageTop[switch.IP_0]: <H1>fc throughput on switch fcswswitch port 0 (mysun jnic0 slot7)</H1> ~snip the error message i am getting is: 2008-08-26 12:03:22: WARNING: Skipping host fcswitch as it does not resolve to an IPv4 address 2008-08-26 12:03:22: WARNING: no data for 1.3.6.1.4.1.1588.2.1.1.1.6.2.1.12&1.3.6.1.4.1.1588.2.1.1.1.6.2.1.11:[EMAIL PROTECTED] Skipping further queries for Host fcswitch in this round. 2008-08-26 12:03:22: ERROR: Target[xxx.xxx.xxx.xx_0][_IN_] ' $target->[0]{$mode} ' did not eval into defined data 2008-08-26 12:03:22: ERROR: Target[xxx.xxx.xxx.xx_0][_OUT_] ' $target->[0]{$mode} ' did not eval into defined data can any one give me any insight on this, ?? Thanks
_______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
