So replace the name fcswitch with the ip address or put fcswitch in your hosts file with the IP you want to use. The answer to you problem is right in the error message.
Skipping host fcswitch as it does not resolve to an IPv4 address _____ From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of anjini shukla Sent: Wednesday, August 27, 2008 12:53 PM To: anjini shukla Cc: [email protected] Subject: Re: [mrtg] MRTG Brocade switch monitoring error I can ping this host, and reply is IP.xx.xx.xx is alive. I can also do an snmpwalk with this ip address.:( Thanks, Anjini On Wed, Aug 27, 2008 at 5:02 AM, Matthew Petach <[EMAIL PROTECTED]> wrote: The crucial line is WARNING: Skipping host fcswitch as it does not resolve to an IPv4 address Make sure that the name you put in your config file is the right name for the device; if you can't ping it by that name, MRTG can't do anything as far as monitoring it. Matt ----- Original Message ---- From: anjini shukla <[EMAIL PROTECTED]> To: [email protected] Sent: Tuesday, August 26, 2008 4:56:12 PM Subject: [mrtg] MRTG Brocade switch monitoring error Hello, I am trying to plot graphs for my Brocade 4100 SAN switch and am using Solaris 10, I am following the documentation given: http://www.xolution.ch/mrtg/ i have written my config file: ~ snip Target[switch.IP_0]: 1.3.6.1.4.1.1588.2.1.1.1.6.2.1.12.1&1.3.6.1.4.1.1588.2.1.1.1.6.2.1.11.1:publ [EMAIL PROTECTED] Title[switch.IP_0]: fc throughput on switch fcswitch port 0 (mysun jnic0 slot7) PageTop[switch.IP_0]: <H1>fc throughput on switch fcswswitch port 0 (mysun jnic0 slot7)</H1> ~snip the error message i am getting is: 2008-08-26 12:03:22: WARNING: Skipping host fcswitch as it does not resolve to an IPv4 address 2008-08-26 12:03:22: WARNING: no data for 1.3.6.1.4.1.1588.2.1.1.1.6.2.1.12&1.3.6.1.4.1.1588.2.1.1.1.6.2.1.11:[EMAIL PROTECTED] cswitch. Skipping further queries for Host fcswitch in this round. 2008-08-26 12:03:22: ERROR: Target[xxx.xxx.xxx.xx_0][_IN_] ' $target->[0]{$mode} ' did not eval into defined data 2008-08-26 12:03:22: ERROR: Target[xxx.xxx.xxx.xx_0][_OUT_] ' $target->[0]{$mode} ' did not eval into defined data can any one give me any insight on this, ?? Thanks
_______________________________________________ mrtg mailing list [email protected] https://lists.oetiker.ch/cgi-bin/listinfo/mrtg
