On Thursday 17 August 2006 02:36 am, Mahadev Karadigudda wrote: > Philippe C. Martin wrote: > >On Tuesday 08 August 2006 08:32 pm, jackie wong wrote: > >>Dear all, > >> > >> For the Get Response Command, is it sent from the reader to the card or > >>vice versa? > >> > >> There is a definition i get from the draft of ISO document on Get > >>Response Command: > >> > >> "The Get Response Command is used to transmit from the card to the > >>interface devices APDU which otehrwise could not be transmitted by the > >>available protocol." > >> > >> It seem to me that the Get Response Command is sent from the card to > >> the reader from the above definition. However for me, i feel that the > >> Get Response Command should be sent from the reader to card in order to > >> get response (extra data still available) from card correspond to the > >> previously sent command. Is that right? Please verify this for me. > >> > >> Thanks. > >> > >> Regards, > >> Jackie Wong > >> > >> > >>--------------------------------- > >>How low will we go? Check out Yahoo! Messenger’s low PC-to-Phone call > >>rates. > > > >Get response must be sent to the card from the host (not from the reader) > > when in T=0 the card responds 61xx to an APDU with a response needed (Le > > !=0) > > I think Le can be 0 and a value of 0 means a 256 byte response. > > Regards > -Mahadev > > _______________________________________________ > Muscle mailing list > [email protected] > http://lists.drizzle.com/mailman/listinfo/muscle
My apologies, I meant "Le not empty". Philippe -- _________________________ Philippe C. Martin www.snakecard.com _________________________ _______________________________________________ Muscle mailing list [email protected] http://lists.drizzle.com/mailman/listinfo/muscle
