Great to hear all is OK Neil, I wasted a lot of time trying to get dual adaptors to work back then. That is why I went with the two sockets.
John From: [email protected] [mailto:[email protected]] On Behalf Of nbreeden Sent: Monday, May 5, 2014 9:38 PM To: [email protected] Subject: [N8VEM-S100:3510] Re: Help with Dual CF S-100 IDE VERSION 02 OK, I understand the core issue. The CF adapters I have can be dual CF adapters; they however only have the connector for one CF card installed. They way they are made they are 'upside' down when I connect them to the IDE controller as is shown on the S100Computers website; the result is the pins on the connector are reversed. If I force the CF adapter onto the IDE board connector upside down things work as expected; this however means the CF card etc. are facing the IDE board and everything is under stress. There was a note that there had been issues with the 'dual CF adapters' not working, I'm guessing this is why. If you look at the attached photo you can see that the alignment tab on the connector faces up (same side as the electronics), on my adapters this alignment notch is on the backside of the adapter board; I actually had to trim it off which should have been a big clue there was an issue. I'll look to order some new adapters. CF Card Adaptor <http://www.s100computers.com/My%20System%20Pages/IDE%20Board/CF%20Card%20Adaptor.jpg> -Neil -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
