John - I assume this was with the CY62167ELL-45ZXI ram?
Todd - Let the group know when you're ready to ship out a few! - Gary On Tuesday, July 22, 2014 9:09:44 PM UTC-4, monahanz wrote: > > Todd just a quick note to let you know the V06c version of the mezzanine > boards checked out fine on the 16MG S100 RAM board. I hammered them > fairly good with the 80386 board, they did fine. > > > > Soldering the chips on to the board is quite tricky. I found it best to > aligen one corner, then orientate the chip and do the diagonally opposite > corner, then run the salder tip along the pins. With a wet tip there is > enough solder on the pins and the board for contact. However I had one > chip where the pin did not make contact, took me a while to locate it. These > boards are definatly not for anybody with shakey hands > > > Will next do the 32MB 80386 board, but for now I feel confident sending > them out to all 16MB board users. > > Thanks Andrew and Dave for all your help on these. > > > > John > > > -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
