Hi Gary (et al.) I can ship the V06c SRAM mezzanine boards whenever anyone wants. $3/board and I can probably ship first class in a regular envelope with cardboard around the boards depending on number to ship.
Thanks, Todd * [email protected] <[email protected]> [140723 09:26]: > John - > > I assume this was with the CY62167ELL-45ZXI ram? > > Todd - > > Let the group know when you're ready to ship out a few! > > - Gary > > On Tuesday, July 22, 2014 9:09:44 PM UTC-4, monahanz wrote: > > > > Todd just a quick note to let you know the V06c version of the mezzanine > > boards checked out fine on the 16MG S100 RAM board. I hammered them > > fairly good with the 80386 board, they did fine. > > > > > > > > Soldering the chips on to the board is quite tricky. I found it best to > > aligen one corner, then orientate the chip and do the diagonally opposite > > corner, then run the salder tip along the pins. With a wet tip there is > > enough solder on the pins and the board for contact. However I had one > > chip where the pin did not make contact, took me a while to locate it. > > These > > boards are definatly not for anybody with shakey hands > > > > > > Will next do the 32MB 80386 board, but for now I feel confident sending > > them out to all 16MB board users. > > > > Thanks Andrew and Dave for all your help on these. > > > > > > > > John > > > > > > > > -- > You received this message because you are subscribed to the Google Groups > "N8VEM-S100" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
