Yes Todd from Arrow. They are specked as 5V but the seem to work OK at 3.3V.
John From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Wednesday, July 23, 2014 6:26 AM To: [email protected] Subject: [N8VEM-S100:4675] Re: S-100-16M-SRAM-MEZZ-V6c Board - Status --- OK John - I assume this was with the CY62167ELL-45ZXI ram? Todd - Let the group know when you're ready to ship out a few! - Gary On Tuesday, July 22, 2014 9:09:44 PM UTC-4, monahanz wrote: Todd just a quick note to let you know the V06c version of the mezzanine boards checked out fine on the 16MG S100 RAM board. I hammered them fairly good with the 80386 board, they did fine. Soldering the chips on to the board is quite tricky. I found it best to aligen one corner, then orientate the chip and do the diagonally opposite corner, then run the salder tip along the pins. With a wet tip there is enough solder on the pins and the board for contact. However I had one chip where the pin did not make contact, took me a while to locate it. These boards are definatly not for anybody with shakey hands Will next do the 32MB 80386 board, but for now I feel confident sending them out to all 16MB board users. Thanks Andrew and Dave for all your help on these. John -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
