Laser cutting wood ? Does't that give burned edges ? eric
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of John Rehwinkel Sent: zondag 30 januari 2011 14:17 To: [email protected] Subject: Re: [neonixie-l] Re: Where to get cool clock housings? > These same tools will work with plastic, though you need to take a bit > more care. I decided to switch gases temporarily, CO2 instead of neon. I bought one of the cheap Chinese laser cutters, and plan to swap out the primitive control board and software for modern ones. It'll cheerfully cut wood and many plastics. And cool housings is one of the reasons I'm doing this! This option is open to folks without laser cutters too - there are some commercial services that will do this for you (I've used both Pololu and Spikenzie with good results), just draft up your file, send it to them, and they send you the cut pieces. - John -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To post to this group, send an email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/neonixie-l?hl=en-GB. -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To post to this group, send an email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/neonixie-l?hl=en-GB.
