"Vibrated into oblivion" There's a surprise haha. Yes was thinking
down the cable grommet route, around the base and tops of the tube(s)
rather than the nipples and/or mounting using silicon 'sealant'.
Circuit boards using anti-vibration mountings too. That should reduce
the higher frequency vibrations, although I am concerned about the
lower and harder end i.e Pot holes/bumps etc. ('Harder' frequencies??
Now that's bad grammar!)My thinking is end view tubes are more robust but really want to use some end view types as well. I'm also wanting to use some IN-9's which seem to have surfaced a lot lately at reasonable prices. > One fellow in England put some on his motorcycle and they vibrated > themselves into oblivion, but a car is much more cushy than a bike. > > Best to mount them with soft rubber shock mount. If they have nipples, > use a grommet over the nipple, placed into a support bracket. > > -- > David Forbes, Tucson AZ -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To post to this group, send an email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/neonixie-l?hl=en-GB.
