Folks,
I have been fortunate to have a young friend with a 3D printer offer to
make a couple prototype cases of my new rechargeable Nixie watch case
for me. I also obtained some larger LiPo batteries.
I've taken the liberty of putting a couple tubes, a transformer and a
200 MaH battery into the case for your amusement.
http://www.cathodecorner.com/nwl-render/nwl_proto1_fronta.jpg
http://www.cathodecorner.com/nwl-render/nwl_proto1_backa.jpg
The empty space in the right side of the case is reserved for the logic
board and pushbutton switches. There's also a micro USB charging port in
there somewhere.
You may notice that the digits aren't vertically centered in the front
opening. That's what prototypes are for.
--
David Forbes, Tucson AZ
--
You received this message because you are subscribed to the Google Groups
"neonixie-l" group.
To post to this group, send an email to [email protected].
To unsubscribe from this group, send email to
[email protected].
For more options, visit this group at
http://groups.google.com/group/neonixie-l?hl=en-GB.
