Note that every device is tested for 100% functionality including all addressing modes and all drivers. This testing is all done with an automated tool through the same I2C interface that you are using. Be sure that SDA and SCL are properly connected with 2.2K pull ups and the interface is running at 100kbps (I2C-Slow).
You can test the processor and drivers stand alone by setting the DIP switches to 1000 (A3 A2 A1 A0) = Off On On On and then powering up the module: When the module boots up with this setting it counts from 0 to 9 in nixie 1-of-10 mode continuously. jt -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/fdd126e0-2d92-4076-b0d7-dba9f673b9ab%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
