Re: [neonixie-l] 2AP1 CRT help

Sat, 21 May 2016 19:55:16 -0700

Hello Steve, Thanks for that. I'm not sure what to make of it. Since Monday, I've sent out 65 replies to various incoming emails, with no problems or issues. I'm NOT very computer savvy to be honest with you, especially the internal workings of the internet. I'm not even sure what an I.P. actually is. I can tell you that this computer of mine is a Windows XP based P.C. here at my home. It is my one and only computer and I've been using it for over ten years now, with very few issues. I'm using Hughes Net satellite service (Directway) for my internet connection. With NO ONE else on that connection. If you can make any suggestions as to what I can/should do, please do let me know. I have no IT person here. No one else uses this computer or connection but me. Thanks again for letting me know.
I had made a phone call recently to ESET regarding my virus protection software, and the call was unknowingly to me, redirected to a third party service company instead of ESET. They gained access to my computer to try and help me with an issue, and wanted to charge me a ton of money to do it. I asked them why it wasn't going to be covered by my virus subscription with them and he told me that they were not ESET but a third party help line. I immediately turned off my computer, and said no thanks and good bye to him. Left it off for about thirty minutes. Came back later, fired it up and all seems well. I don't notice any issues from here. I wonder if they did this? If we can ever get to communicate normally through the email system, I may be able to shed some light on your 2AP1 CRT issue. Thanks for any help or suggestions, Ira. 


On 5/21/2016 7:16 PM, [email protected] wrote:


Ira:


Based on your snippit, the problem is at your end. The IP of the 
machine you’re sending it from is on a “Blacklist” (DNSBL 
MailSpike-BL-W) and thus the recipient’s mail server is rejecting any 
message outright without regards to the recipient’s email address.



I checked myself, and that IP is on no less than 3 blacklists: 
http://mxtoolbox.com/SuperTool.aspx?action=blacklist%3a69.168.97.48&run=toolpage 




The reason for this is typically that IP has been reported for sending 
out SPAM.  It can be from a compromised PC, someone sending out mail 
to a distribution list where a recipient reported the email as 
unwanted, or problems with an email server that is openly relaying 
SPAM from others.



If this is a business (which it appears so) then your IT person should 
get involved.  It is a shared 3^rd party hosting, you should alert 
them to this situation and request your hosting be moved to a 
different IP.


-Steve


*From:*[email protected] 
[mailto:[email protected]] *On Behalf Of *Instrument 
Resources of America

*Sent:* Saturday, May 21, 2016 9:54 PM
*To:* [email protected]
*Subject:* Re: [neonixie-l] 2AP1 CRT help


'Medlabs' was a typo on my part just now in that last message. I had 
been sending to 'madlabs' all along with no luck, always rejected.  
Sent to [email protected] <mailto:[email protected]> again 
just now.  Rejected again on the second go round. Here is a partial 
copy of the message that I'm getting,   Ira


[email protected] <mailto:[email protected]>  (after RCPT TO): 554 
BLK_SYS_15 IP Address (69.168.97.48) of the sender was found in DNSBL MailSpike-BL-W 
and was therefore refused.

On 5/21/2016 4:22 PM, David Forbes wrote:

    madlabs, not medlabs.


    On 5/21/16 2:54 PM, Instrument Resources of America wrote:

    I've tried twice now Johnathan to respond to you on this, and both
    times
    the message comes back to me as being undeliverable. To; J PEAKALL@
    MEDLABS.INFO    Ira.




    On 5/21/2016 12:00 PM, Jonathan Peakall wrote:

    Hi All,

    A little OT, but there are some CRT folks on this list.

    I am working on a Hallicrafters SP-44 Skyrider Panadapter. I have
    done
    a recap/re-resistor job on it. The CRT display isn't quite right, the
    baseline is uneven in width, about right on the left but too wide on
    the right. If anyone has some insight as to what could be causing it,
    I would be very appreciative.

    PLEASE REPLY OFF LIST : jpeakall AT madlabs DOT info

    Many thanks folks!

    Jonathan

--

You received this message because you are subscribed to the Google 
Groups "neonixie-l" group.
To unsubscribe from this group and stop receiving emails from it, send 
an email to [email protected] 
<mailto:[email protected]>.
To post to this group, send email to [email protected] 
<mailto:[email protected]>.
To view this discussion on the web, visit 
https://groups.google.com/d/msgid/neonixie-l/016b9265-0a1c-5396-3f83-5380bf85f2a9%40HUGHES.NET 
<https://groups.google.com/d/msgid/neonixie-l/016b9265-0a1c-5396-3f83-5380bf85f2a9%40HUGHES.NET?utm_medium=email&utm_source=footer>.

For more options, visit https://groups.google.com/d/optout.

--

You received this message because you are subscribed to the Google 
Groups "neonixie-l" group.
To unsubscribe from this group and stop receiving emails from it, send 
an email to [email protected] 
<mailto:[email protected]>.
To post to this group, send email to [email protected] 
<mailto:[email protected]>.
To view this discussion on the web, visit 
https://groups.google.com/d/msgid/neonixie-l/003001d1b3d0%2406dd9750%241498c5f0%24%40liny.net 
<https://groups.google.com/d/msgid/neonixie-l/003001d1b3d0%2406dd9750%241498c5f0%24%40liny.net?utm_medium=email&utm_source=footer>.

For more options, visit https://groups.google.com/d/optout.


--
You received this message because you are subscribed to the Google Groups 
"neonixie-l" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To post to this group, send an email to [email protected].
To view this discussion on the web, visit 
https://groups.google.com/d/msgid/neonixie-l/bcac8d9b-7851-ad8e-0106-2f19da52743f%40HUGHES.NET.
For more options, visit https://groups.google.com/d/optout.

<<attachment: IRACOSALES.vcf>>





















					Reply via email to