Apologies - 3mm thick - I went to my workshop and measured my clock ones and found the IN-18 set too!
On Wednesday, February 8, 2017 at 6:50:42 PM UTC, Roddy Scott wrote: > > They are approximately 2mm thick. Laser cut, film covered, you need to > push out the waste from the pin receptacles on them before inserting the > pins. > > I have the Spectrum 1040 kit variation for Z568M tubes. Pete has a few > different tube mounts for the Spectrum kit depending on which tube you are > using. > > Contact Pete and he should be able to supply the Plexiglass base parts for > the IN-18 tubes. > > If you wanted to make remote 'sockets' from them you could solder wires to > the pins before mounting them and make a small dam around the plexiglass > with tape and flood it with a little 2 part epoxy keeping the socket part > of the pins clear of the epoxy. Then you would just need to put heat shrink > on the connections. > > > -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/2d6bea93-3996-489a-85e6-c939facaaf1b%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
