Hi Richard,
I use Lightburn (https://lightburnsoftware.com/ ) for my K40 laser cutter, it can control a number of different laser cutters depending on the control protocol it uses. It should not be difficult to find out if it supports yours. Cheers, Bill From: [email protected] [mailto:[email protected]] On Behalf Of Richard Scales Sent: Sunday, February 13, 2022 11:42 PM To: neonixie-l <[email protected]> Subject: Re: [neonixie-l] Re: Low profile board for Dalbors tubes For the enclosures I use the following process: FIrstly I lay out the design using Solid Edge 2D drafting software from which I export a DXF File. I use my own laser cutter (Triumph 6040) to cut the parts - their software reads the DXF, I then control which parts I want to cut. Their software is called 'Lasersoft' http://www.triumphlaser.com I find that their software does absolutely everything that I would want it to do - Can anyone recommend any alternatives or are all these products tied to the cutters that the software is supplied with? - Richard On Sunday, 13 February 2022 at 23:09:54 UTC Terry Bowman wrote: On Feb 13, 2022, at 12:47 AM, Richard Scales <[email protected] <mailto:[email protected]> > wrote: I just made a version with green-tint acrylic for a special request. What software are you using to design your enclosures? Who's cutting them? Just curious. Terry Bowman, KA4HJH "The Mac Doctor" https://www.astarcloseup.com “...the book said something astonishing, a very big thought. The stars, it said, were suns but very far away. The Sun was a star but close up.”—Carl Sagan, "The Backbone Of Night", Cosmos, 1980 -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected] <mailto:[email protected]> . To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/4be6ed9b-2e6e-4363-8cf2-90ec1c32684an%40googlegroups.com <https://groups.google.com/d/msgid/neonixie-l/4be6ed9b-2e6e-4363-8cf2-90ec1c32684an%40googlegroups.com?utm_medium=email&utm_source=footer> . -- You received this message because you are subscribed to the Google Groups "neonixie-l" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/neonixie-l/00d801d821a0%24fc68cc00%24f53a6400%24%40gmail.com.
