If you have a modular console it could have something to do with the
molex connectors that connect to the mother-board. Check for cold
solder joints on the modules as-well as the mother-board itself.
I've had problems like that on a few modules that where solved that way.
good luck,
Jared
On Oct 9, 2008, at 2:49 PM, Tom Gorichanaz wrote:
Hello,
I foolishly deleted a previous email regarding this question. I have
several channels (2,3,&4) which the signal is only present on the
right master output. (with pan pot set fully to the right and up to
center) Once pan is turned to the left, the signal disappears. I
believe I was originally told to look at the IC. I have not done that
yet. Any other suggestions?
Thanks,
Tom
