I seem to remember getting a lot of useful information from this
list the last time I addressed my unbalanced/balanced patch bay issues
so I was hoping someone here could answer a couple questions I have
along those same lines:
My patch bay and snakes are balanced and typically to convert the 1/4
connectors on the ends of the snakes that feed the patch pay you just
get new unbalanced connectors AND tie the common and ground/shield
together.
I will be plugging these snakes in to my unbalanced Series One for
it's direct outs, line ins etc and I wanted to make sure this was an
acceptable approach, have any of you tried this before?
I do not need to rewire to an unbalanced patch bay do I?
Thanx,
Jack
Jack Dean Stauss
No Static Pro Audio, Inc.
3083 N. California St.
Burbank Ca. 91504
818-729-8554
818-729-8551 Fax
www.nostaticav.com
[email protected]
Confidentiality Notice: This e-mail message, including any
attachments, is for the sole use of the intended recipient(s) and may
contain confidential and privileged information. Any unauthorized
review, use, disclosure or distribution is prohibited. If you are not
the intended recipient, please contact the sender by reply e-mail and
destroy all copies of the original message
