Also, are you are you are not fiddling with the
> settings. Software does not have artificial intelligence, it doesn't just
> 'stop working' on it's own.
You mean like following a cold boot, I can run the wizard setup,
enter the information for a lan-based setup. complete it and it'll
finish.
Then try it another time after a cold boot, enter exactly the same
information and paths and it won't let me get past the "choose a
name for the sana II config file" screen, even if I delete the
previous enrty.
Then at other times.
It'll run ( I can surf) with no errors.
It will run ( I can surf ) with the error
type information
err sana2_online: could not put devs:networks/cnet.device, unit
0 online
note cnet0 is now online
and it also doesn't run ( no IP activity) with both the above
messages. The first one is bad as it doesn't give any errors but
fails.
This is all with cold boots and is pretty random AND there nothing has
been changed.
Again...if someone has a good setup/config file for the CN40BC, I'd
like a copy.
Martin
>
> Chris.
>
> Active Technologies - Chris Wiles [Managing Director]
> http://www.active-net.co.uk
> Tel: +44 (0)1325 460116 [9-6 Mon-Fri, 10-5 Sat]
> Fax: +44 (0)1325 460117
>
>
>
> _____________________________________________________________
> NetConnect mailing list. To unsubscribe, send an 'unsubcribe'
> message to <[EMAIL PROTECTED]>
>
_____________________________________________________________
NetConnect mailing list. To unsubscribe, send an 'unsubcribe'
message to <[EMAIL PROTECTED]>
