> Hi Folks,
>
> I've just installed a portplus mk2 serial card and on trying to connect I get
> the following error.
>
> crit serial_create: could not open serial device (hyperCOM1.device, Unit 0)
>
> After running the installation off the portplus floppy I found that it had
> indeed put the hyperCOM1.device in DEVS: (Version 2.89beta) and 2 libraries in
> LIBS:
>
> I changed my modem device in netconnect to hyperCOM1.device unit 0 (previously
>serial.device) and then left everything else as it was.
>
> The error mentioned above happens almost instantly after clicking on CONNECT.
> There is no visible or audible modem activity at all.
>
> I've checked all external connections and everything seems fine. I can only think
>that maybe the clock port header has come loose when reassembling the 1200. I was
>careful not to clip the iface cable on the casing clips.
>
I've only just seen this message which MDII tells me is 31days old! So if you
had a response ignore this.
I've just installed a Port Junior and experienced EXACTLY the same problems
which came down to dodgey software. I was sent the latest programme and
my PJ worked immediately - using it now.
Contact your supplier and they should
send you an updated copy. If a problem drop me a
line.
--
Philip Wagstaff
_____________________________________________________________
NetConnect mailing list. To unsubscribe, send an 'unsubcribe'
message to <[EMAIL PROTECTED]>
