-----Original Message-----
From: Richard Adams [mailto:[EMAIL PROTECTED]]
Sent: Friday, September 24, 1999 3:32 AM
To: [EMAIL PROTECTED]
Subject: Re: [newbie] SCSI card not recognized at boot
If you simply use a conf option example from someone else make sure
that IRQ is not in use, if it is then that is possably the reason why
conf.modules crashed your machine.
Setserial will do exachtly the same, i suggest you read the SCSI
HOWTO found in /usr/doc/* and find out which IRQ's are used and which
are resurved for PCI devices, before you do anything else.
--
Regards Richard
[EMAIL PROTECTED]
The IRQ was the one set on the jumpers on the card. Unless some of the
IRQ's are being rearranged, I don't think anything else is using 10, since
that's what Win98 is using for it. This card is NOT PNP by the way.
The SCSI howto was not helpful.
Mark
