Rune Kallhovd wrote: > > Hi folks! > > I have run into some serious problems installing Mandrake 7.2 on > my box, having the following specs: > > - Abit BE6-II motherboard (not version 2), latest BIOS (UH) > > - Celeron 466 > > - 256 MB RAM > > - Two HD's on UDMA66 (HPT366), both IBM. > /dev/hde - IBM 30GB, 7200rpm, ATA66/100 (boot) > /dev/hdf - IBM 13.5GB, 7200rpm, ATA66 > > - DVD/CD and CD-RW > /dev/hda - Pioneer 10/40 DVD/CD > /dev/hdb - HP 9100i > > - Matrox G400 MAX DualHead > > - Creative 1024 Live! > > Installation goes quite well, but reboot after installation just > chokes when init is starting. I heard someone mention that there > is a bug in 7.2 that requires you to disable the primary slave > drive in BIOS when installing 7.2. Then download and install a > patch of some sort before enabling the slave drive again. > Is this so, and could someone point me to where I might find the > solution to this? > > I tried to search for this in the archives here, but could not > find anything. > > Mandrake 7.1 installs just fine on the same box, but I ran into > similar problems when I opted for 'disk optimization' during the > installation. Boot got stuck when 'preparing disk optimization for > /dev/hdf'. This leads me to suspect there is some problems with > having a slave drive when installing 7.2? > > BTW, None of the drives are 'contaminated' with Windoze. If this is downloadable 7.2, try installing in "expert" mode and turning off optimizations. This particular MB/Chipset/Controller combo often chokes on some of them. Check the expert archives or Cooker archives for case histories if interested. If this is not downloadable 7.2, either download it or register your set and contact tech support by email; or get a cheap set of CDs from Cheapbytes or GatorOnline. Civileme > > -- Cheers! > ====== Rune Kallhovd, CORENA Norge AS ====== > = Software Engineer = > = P.O.Box 1024, N-3601 Kongsberg, NORWAY = > = Tlf: +47 32 73 7448, Fax: +47 32 73 6877 = > == CORENA Home Page: http://www.corena.no ==
