> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of civileme
> Sent: Sunday, January 07, 2001 12:19 PM
> To: [EMAIL PROTECTED]
> Subject: Re: [newbie] Boot disk for Corp Server 1.1 that enables DMA?
> 
> 
> On Sunday 07 January 2001 17:07, you wrote:
> > I'm sorry, I am kind of new at all this I believe I mislead you 
> in thinking
> > that the system is already installed. It is not. I am trying to install
> > corp server 1.1 on a box with 2 ata100 drives and I can't get 
> corp server
> > 1.1 to find the drives. What do I have to do to fix this?
> >
> > I have an Abit KT7-RAID motherboard
> >
> > Thank you,
> > Steve
> >
> OK  There is I believe a standard 33 MHz ide channel on board
> 
> Put an ide disk on that port and do a minimal install
> 
> run "cat /proc/pci" from a console--you do not need X
> 
> somewhere in the output you will see five numbers of a form like 0x9902 
> 0xa740, and so on record the first two of these numbers and restore your 
> setup to its original form
> 
> to the second number add 2 in hexadecimal arithmetic.
> 
> Now fire it up and  at the splash screen hit F1
> 
> type in
> 
> linux idebus=33 ide2=0x9902 0xa742
> 
> but use your numbers, not mine
> 
> If you have two sets of  5 numbers, that's OK--one of them will 
> be ide2 and 
> the other ide3 which is which?  Well, it doesn't hurt to 
> experiment on that 
> since nothing is committed til the install is done.
> 
> Now it should see your controller but limit it to 33MHz for the install.
> 
> And, you need to put the ide2= and perhaps ide3= to the append at the 
> bootloader step of install as well.
> 
> It will not be possibel to make corporate server see the ATA/100 
> drives as 
> 100s--66 is the limit for that kernel.  Corporate servers are not 
> issued on 
> the same schedule as desktops and are based on proven software 
> exclusively.  
> The reasons for this are marketing-based....  Server customers 
> are usually 
> large systems who don't like to upgrade every 4-6 months.
> 
> Civileme

Thanks! I'll give it a try.

Steve

Reply via email to