Thank for your reply. I am hereby attaching the XF86Config file (i.e. XF86Config) The Error Log I get when i run XFree86 -configure (i.e. XFree86.log) and the error log when I get while running startx 2>mylog (i.e.mylog)
If you check the XFree86.log it complains at the bottom about the missing card info in the xf86PciInfo.h which I have already included in that file but after compiling the kernel using make World and make Install , it didn;t generate the XF86Config-4 file, So I am sure even after installing the XFree86 v4.1.0 it was still running the old one. Ne clues on installation. Thank a lot again Anish.. ----- Original Message ----- From: "Lionel Lecoq" <[EMAIL PROTECTED]> To: "Anish Jhaveri" <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]> Cc: <[EMAIL PROTECTED]> Sent: Wednesday, January 23, 2002 11:43 AM Subject: Re: [Newbie]S3-VIS Twister Chip set for XFree86 > Before assuming the worst, I would run XFree86 -configure this should generate a reasonable config > file (NOTE: it will be located in your root directory and be called XF86Config.new, you will have > to rename it and move it where it belongs) > Then if you still have problems post both XF86Config and log -preferably the one generated by > startx 2>mylog (to be found in current directory/mylog) > Lionel > > --- Anish Jhaveri <[EMAIL PROTECTED]> wrote: > > I guess you are right. There is only one XF86Config file i.e. XF86Config > > which seems to be for version 3.3.*. Actually I downloaded the Source for > > 4.1.0 changed the file names xf86PciInfo.h to include my device ID. There > > after I run the make World and make install. > > __________________________________________________ > Do You Yahoo!? > Send FREE video emails in Yahoo! Mail! > http://promo.yahoo.com/videomail/
XFree86.log
Description: Binary data
XF86Config
Description: Binary data
MYLOG
Description: Binary data
