The config I sent you specified a 1024x768 resolution. If you only have 800x600 then
you must
change the mode line.
If you have more than one resolution in your mode line then the largest will be taken
as virtual
resolution
i.e. if you have
Modes "1024x768" "800x600" "1280x1024"
Then the window will be generated for a 1280x1024 "virtual" screen
if you monitor shows only 1024x768 then you will see only part of the screen
Lionel
--- Anish Jhaveri <[EMAIL PROTECTED]> wrote:
> Thank You Very much for your file.
> It was very useful. Thereafter I could create a new XF86Config-4 using
> Xconfigurator specifically for
> driver chip whihc was nearest to one I am using.
> I am still having a problem with XConfigurator, it starts the XServer using
> startx but it doesn't load the whole image
> of the window it just loads the part of it(i.e part of Terminal window is
> only viewable as it cover the whole screen.)
>
> Do you know where I could change the further configuration details.?
>
> Thank a lot for your help.
> Anish
>
>
__________________________________________________
Do You Yahoo!?
Great stuff seeking new owners in Yahoo! Auctions!
http://auctions.yahoo.com
_______________________________________________
Newbie mailing list
[EMAIL PROTECTED]
*** To unsubscribe , or change message options, see:
http://XFree86.Org/mailman/listinfo/newbie
