Hello All,
I am observing strange behaviour, which I had not encountered
earlier. I have been able to configure and run a multihead
setup successfully with my ATI and Matrox VGA cards previously.
This time round [ on a fresh installation ], the introduction of
a second card [Matrox], causes the boot-up to throw a messsage
from gpm.c which says
gpm.c (line 978) (oops). /dev/mouse "Device busy"...
I cannot remember the exact string since, the message disappears
during boot-up and is not logged anywhere.
Nevertheless, this is not allowing "X" to come up. This problem
does not occur if only 1 video card exists in the system.
Setup - Redhat 7.1 Linux
i386 arch
Acer 6000
ATI [ built-in VGA ]
MAtrox [ Add-on VGA ]
- I never observed such behaviour earlier, but, if someone can shed
some light on this, I will be very grateful and would be able to
get going with my work ASAP.....
- Please do try to let me know .....
- Thank you very much
- Shobhit Mathur [ [EMAIL PROTECTED] ]
**************************Disclaimer************************************
Information contained in this E-MAIL being proprietary to Wipro Limited
is 'privileged' and 'confidential' and intended for use only by the
individual or entity to which it is addressed. You are notified that any
use, copying or dissemination of the information contained in the E-MAIL
in any manner whatsoever is strictly prohibited.
********************************************************************
