I don't know whether 3.3.6 is included with RH 7.3 (it was with all the previous RH 7.x) If it is you can do as Shane suggested BUT in /etc/X11 NOT in /usr/X11R6/bin (at least in my RH setup this is the one which is used...). However, the config file is not anymore the same... Theoretically you should have two configs in your /etc/X11 directory one named XF86Config with the right format for 3.3.6 the other name XF86Config-4 for 4.2. Regrettably sometimes the RH install (from 7.2 upward) decides that one suffices (usually when it considers the card well enough supported in 4.2) IN SHORT in /etc/X11/: rename X (for instance X4) if you have only an XF86Config back it up create X as a symlink to /usr/X11R6/bin/XFree86_SVGA run Xconfigurator, I would not run the test of the conf. sometimes it bums out even when everything is OK, thus messing up the conf. Good luck Lionel
--- Spandan Bhatt <[EMAIL PROTECTED]> wrote: > > --- Lionel Lecoq <[EMAIL PROTECTED]> wrote: > > have you tried 3.3.6? > Umm 3.3.6 what? Sorry but I couldnt get which sw you > mean. The Xfree86 is the version bundled with RH7.3 > Thanx for your replies > Spundun > > Lionel > > > __________________________________________________ > Do You Yahoo!? > Yahoo! - Official partner of 2002 FIFA World Cup > http://fifaworldcup.yahoo.com > _______________________________________________ > Newbie mailing list > [EMAIL PROTECTED] > *** To unsubscribe , or change message options, see: > http://XFree86.Org/mailman/listinfo/newbie __________________________________________________ Do You Yahoo!? Yahoo! - Official partner of 2002 FIFA World Cup http://fifaworldcup.yahoo.com _______________________________________________ Newbie mailing list [EMAIL PROTECTED] *** To unsubscribe , or change message options, see: http://XFree86.Org/mailman/listinfo/newbie
