You don't need to unsolder the wires from the bulb socket.. You disconnect the wires f(female / male ends on the wires) in the headlight and for the back ones you can access the wired socket under the seat.
That is the the way it is intended to be performed - same as if you were replacing the whole blinker assembly. On Oct 4, 6:12 am, Coder <[email protected]> wrote: > Here is the link to the assembly/schematic I am trying to describe > from the dealership. Hope this is helpful. > > http://www.tousleymotorsports.com/fiche_section_detail.asp?section=12... > > On Oct 2, 9:39 am, stanley/ Randolph <[email protected]> wrote: > > > > > The wires have to go through the rubber "pipe" thingy... > > > > Stanley > > > ________________________________ > > From: oldschoolgwin <[email protected]> > > To: Nighthawk Motorcycle Lovers! <[email protected]> > > Sent: Thursday, October 1, 2009 10:16:22 PM > > Subject: [Nighthawk Lovers] Re: Broken rubber piece holding front turn > > signal > > > Why do you need to pull the wiring out? If replacing just the rubber > > piece don't you just need to slide the new rubber part on in the same > > manner you removed the old one? Maybe i missed the point of the > > question? > > > Did you buy a Honda OEM part or were you able to find a reasobly > > priced after market replacement? > > > If aftermarket could you please list the source - I need 4 of them > > (but not at the OEM prices). > > > Thanks > > > On Oct 1, 6:20 pm, Coder <[email protected]> wrote: > > > > Hi all. > > > > I have never posted here before and really am a neophyte relative to > > > motorcycle repairs. > > > > One of the rubber pieces that hold the turn signal cracked on my bike > > > (1984 650 Nighthawk). I have purchased the replacement parts, removed > > > the existing rubber piece from the headlight bracket, taken off the > > > turn signal cover and removed the bulb, but I am stumped regarding how > > > to remove the old wiring and socket (that holds the bulb) from the > > > turn signal itself. I am afraid to keep pulling/twisting as I think I > > > will damage the wiring and cause a bigger problem than I have. > > > > Thanks for any help that you can provide-- Hide quoted text - > > > - Show quoted text -- Hide quoted text - > > - Show quoted text - --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/nighthawk_lovers?hl=en -~----------~----~----~----~------~----~------~--~---
