I tried to remove the carb bowl today but the bolts were really tight and it looked like the Phillips head was going to strip, so I didn’t go any further. I started the bike, but it ran really bad. I touched the manifold pipes and 1 and 3 were hot, but 2 was warm and 4 cold. I then noticed that fuel was coming out of number 4 where the header meets the engine. I replaced the exhaust a few weeks ago and after starting the bike a few times, they needed re-torquing. The nuts on all four pipes needed tightening. Started the bike again and it ran better. Touched the manifolds again, and again 1 and 3 were hot and 2 and 4 were also hot but not as hot as the others. If the problem is the carbs then I’ll take them off and inspect. Any ideas guys ?
-- You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at https://groups.google.com/group/nighthawk_lovers. To view this discussion on the web visit https://groups.google.com/d/msgid/nighthawk_lovers/233e487d-b6ee-4c03-8a53-b632405d6942%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
