If it ain't broke don't fix it. Seriously, the numbers you provided don't indicate any issues. Just enjoy your ride. Dave
On Sat, 9 Nov 2019 at 00:13, aajawo <aaronjworst...@gmail.com> wrote: > So I've been thinking about doing the top end on my 1983 Nighthawk 650 for > a few reasons. The compression on all four cylinders is a little low at > 120 psi. That is tested with the engine warm and throttle wide open. The > shop manual spec is 170 psi. But, correcting for my elevation of 7,000 > feet, that would be more like about 134 psi. So maybe 120 psi isn't too > bad??? > > Also, I'm getting oil in the drain tube that comes off the separator tank > attached to the the crankcase breather - maybe an inch of oil will collect > over the course of a 50 mile ride (pictured). The airbox which is connected > to the separator tank also has oil in it. My guess is that I am getting > some blow by past the rings which is forcing vapors out the crankcase > breather into the separator tank and airbox where they collect. > > The bike doesn't visibly smoke, but I can smell either oil or unburned gas > when I let the bike idle in the garage. > > The plugs don't look too bad - a little too brown maybe, but dry > (pictured). > > Originally, the number 2 cylinder was only reading about 105 psi. But now > that all four cylinders are at 120 psi, I am having second thoughts about > doing a top end. > > The top-end job would include a cylinder hone, new rings, lapping valves, > new valve seals, new gaskets, and anything else I might run in to. > > I think I could do it myself. I already have a top end gasket kit. Rings > would be about $100. As long as I don't run into other issues, the cost > isn't too bad. > > What do y'all think? Is it necessary? > > > -- > You received this message because you are subscribed to the Google Groups > "Nighthawk Motorcycle Lovers!" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to nighthawk_lovers+unsubscr...@googlegroups.com. > To view this discussion on the web visit > https://groups.google.com/d/msgid/nighthawk_lovers/d584d518-3f7d-40db-951d-131bc7880e0c%40googlegroups.com > <https://groups.google.com/d/msgid/nighthawk_lovers/d584d518-3f7d-40db-951d-131bc7880e0c%40googlegroups.com?utm_medium=email&utm_source=footer> > . > -- If you forward this e-mail please remove my address. -- You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To unsubscribe from this group and stop receiving emails from it, send an email to nighthawk_lovers+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/nighthawk_lovers/CAAVdLpbnUNagGidg-%3DK1VAWhCD7bh4bPKQk6AOGFbY1SiK9YdA%40mail.gmail.com.
