On 06/14/2012 03:25 PM, Mike Burns wrote: > The image is posted to the beta area on ovirt.org[1]. There will likely > be a 2.4.1 release in the next couple weeks as we clean up some other > issues.
I just did a test install and this is the result so far: When booting the iso itself and the installed node later I get the following output: rpcbind: rpcbind terminating on signal. Restart with "rpcbind -w" the boot process continues though. I can't seem to configure the network. When I move to "eth0" and hit enter I see a blue screen for about 20 seconds and then I get back to the grey background with header and footer but nothing in the content area. Hitting a cursor key the menu appears but in the top left corner instead of where it's supposed to be. Selecting anything doesn't change the content are though. When I hit f12 the gui apparently resets and everything looks alright again. Looking at the logs I see ovirtfunctions - unable to determine ip/netmask from: ovirtfunctions - unable to determine ip/netmask from: Device "breth0" does not exist. Is there a manual way to configure the networking so I can test the engine connection? Regards, Dennis _______________________________________________ node-devel mailing list [email protected] http://lists.ovirt.org/mailman/listinfo/node-devel
