On Thu, 2012-06-14 at 18:50 +0200, Dennis Jacobfeuerborn wrote: > On 06/14/2012 03:25 PM, Mike Burns wrote: > > The image is posted to the beta area on ovirt.org[1]. There will likely > > be a 2.4.1 release in the next couple weeks as we clean up some other > > issues. > > I just did a test install and this is the result so far: > > When booting the iso itself and the installed node later I get the > following output: > rpcbind: rpcbind terminating on signal. Restart with "rpcbind -w" > the boot process continues though. > > I can't seem to configure the network. When I move to "eth0" and hit enter > I see a blue screen for about 20 seconds and then I get back to the grey > background with header and footer but nothing in the content area. Hitting > a cursor key the menu appears but in the top left corner instead of where > it's supposed to be. Selecting anything doesn't change the content are > though. When I hit f12 the gui apparently resets and everything looks > alright again. >
Argh, we were seeing this in builds just before the official one. There was a patch that fixed it that was apparently missed int the build. I'm respinning a new 2.4.0 build now (2.4.0-1 actually). Mike > Looking at the logs I see > ovirtfunctions - unable to determine ip/netmask from: > ovirtfunctions - unable to determine ip/netmask from: Device "breth0" does > not exist. > > Is there a manual way to configure the networking so I can test the engine > connection? > > Regards, > Dennis > _______________________________________________ > node-devel mailing list > [email protected] > http://lists.ovirt.org/mailman/listinfo/node-devel _______________________________________________ node-devel mailing list [email protected] http://lists.ovirt.org/mailman/listinfo/node-devel
