On Thu, 2012-06-14 at 23:32 +0200, Dennis Jacobfeuerborn wrote: > Thanks! With the new iso I can successfully configure the network. > When I try to register the node with the engine I get the same problem > though. I select "oVirt Engine", enter the IP of the engine system and hit > apply and get the same menu problem as with the Network option before. > > Regards, > Dennis
Hi Dennis, I've had another report of the same issue [1]. It's being investigated now. Mike [1] https://bugzilla.redhat.com/show_bug.cgi?id=832196 > > On 06/14/2012 07:58 PM, Mike Burns wrote: > > 2.4.0-1 is now posted in the same place as 2.4.0. It includes a fix for > > the network screen not working correctly (patch was merged, but was > > missing from my repo when I built). > > > > Mike > > > > On Thu, 2012-06-14 at 13:10 -0400, Mike Burns wrote: > >> On Thu, 2012-06-14 at 18:50 +0200, Dennis Jacobfeuerborn wrote: > >>> On 06/14/2012 03:25 PM, Mike Burns wrote: > >>>> The image is posted to the beta area on ovirt.org[1]. There will likely > >>>> be a 2.4.1 release in the next couple weeks as we clean up some other > >>>> issues. > >>> > >>> I just did a test install and this is the result so far: > >>> > >>> When booting the iso itself and the installed node later I get the > >>> following output: > >>> rpcbind: rpcbind terminating on signal. Restart with "rpcbind -w" > >>> the boot process continues though. > >>> > >>> I can't seem to configure the network. When I move to "eth0" and hit enter > >>> I see a blue screen for about 20 seconds and then I get back to the grey > >>> background with header and footer but nothing in the content area. Hitting > >>> a cursor key the menu appears but in the top left corner instead of where > >>> it's supposed to be. Selecting anything doesn't change the content are > >>> though. When I hit f12 the gui apparently resets and everything looks > >>> alright again. > >>> > >> > >> Argh, we were seeing this in builds just before the official one. > >> There was a patch that fixed it that was apparently missed int the > >> build. I'm respinning a new 2.4.0 build now (2.4.0-1 actually). > >> > >> Mike > >> > >> > >>> Looking at the logs I see > >>> ovirtfunctions - unable to determine ip/netmask from: > >>> ovirtfunctions - unable to determine ip/netmask from: Device "breth0" does > >>> not exist. > >>> > >>> Is there a manual way to configure the networking so I can test the engine > >>> connection? > >>> > >>> Regards, > >>> Dennis > >>> _______________________________________________ > >>> node-devel mailing list > >>> [email protected] > >>> http://lists.ovirt.org/mailman/listinfo/node-devel > >> > >> > >> _______________________________________________ > >> node-devel mailing list > >> [email protected] > >> http://lists.ovirt.org/mailman/listinfo/node-devel > > > > > > _______________________________________________ > node-devel mailing list > [email protected] > http://lists.ovirt.org/mailman/listinfo/node-devel _______________________________________________ node-devel mailing list [email protected] http://lists.ovirt.org/mailman/listinfo/node-devel
