https://bugs.freedesktop.org/show_bug.cgi?id=38074
--- Comment #5 from Jaromír Cápík <[email protected]> 2011-07-28 09:33:22 PDT --- >It seems plausible the 1280x1024 display only works because >it's using the analog function of the connector and not the digital. >I suspect that if you plugged another display in digitally >on that port it'd still fail. According to my NOTE #2 it's possible ... >How exactly does it fail by the way, >just the second display not showing an image? Second display probably has no signal or unsupported signal (LED blinking and display seems to be off). >If you boot with a 1920x1080 display on the left connector, >and plug the right, what happens? What about the reverse? >(Just trying to rule out if it's a problem with a particular >connector, or with programming an output without vbios assistance). I've tried to swap the connectors, and the result was the same. The problem is always with DVI-I-2. If I try to boot with monitor connected in DVI-I-2 only, then I see post messages and GRUB, but once the kernel starts booting and activate the framebuffer, then the screen on DVI-I-2 goes black (and LED starts to blink) and the rest of the kernel boot messages is being displayed on DVI-I-1 (disconnected at that moment) .... That means ... DVI-I-1 always works, DVI-I-2 never works -- Configure bugmail: https://bugs.freedesktop.org/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are the assignee for the bug. _______________________________________________ Nouveau mailing list [email protected] http://lists.freedesktop.org/mailman/listinfo/nouveau
