Ha, that isn't perhaps as bad as it sounds actually! :)
2011/8/24 Pat Wong <[email protected]> > use a wacom pen and a ruler :) > > > > > > On 24 August 2011 13:58, Tim BOWMAN <[email protected]> wrote: > > In a fit of desperation I once made a paintstroke that approximated my > > desired line, then deleted all the knots except the first one and the > last > > one. It wasn't fancy, but it worked. > > > > -t > > > > > > On Wed, Aug 24, 2011 at 6:17 AM, Nuke <[email protected]> wrote: > >> > >> Not in front of Nuke at the moment, and I can't remember if there is a > >> modifier to to so...two workarounds: > >> A - You could draw a spline then use Feather and Falloff attributes to > >> give it width + softness/hardness. > >> B - Draw a straight line as best you can with the brush, then edit the > >> stroke, selecting and deleting the points in between the ends. > >> Hope that helps - > >> > >> Craig Tozzi > >> twothousandstrong > >> venice, ca > >> > >> > >> On Aug 23, 2011, at 1:13 PM, Howard Cabalfin wrote: > >> > >> Anyone know how to create a straight line using the Nuke RotoPaint Node? > >> I've tried holding down the modifier keys such as shift or alt while > >> painting but no straight line. > >> > >> > >> _______________________________________________ > >> Nuke-users mailing list > >> [email protected], http://forums.thefoundry.co.uk/ > >> http://support.thefoundry.co.uk/cgi-bin/mailman/listinfo/nuke-users > > > > > > _______________________________________________ > > Nuke-users mailing list > > [email protected], http://forums.thefoundry.co.uk/ > > http://support.thefoundry.co.uk/cgi-bin/mailman/listinfo/nuke-users > > > _______________________________________________ > Nuke-users mailing list > [email protected], http://forums.thefoundry.co.uk/ > http://support.thefoundry.co.uk/cgi-bin/mailman/listinfo/nuke-users > -- Freelance Nuke Op. www.torbjornlindback.com +44 7754 193 130 <http://www.torbjornlindback.com/>
_______________________________________________ Nuke-users mailing list [email protected], http://forums.thefoundry.co.uk/ http://support.thefoundry.co.uk/cgi-bin/mailman/listinfo/nuke-users
