Please try the "powermust" driver (or "megatec", if you are willing to try the development branch).
On 4/21/06, lonely wolf <[EMAIL PROTECTED]> wrote: > Hello > > I have just purchased a Mars Convertible MS3000RT UPS > (http://www.uisabler.com.tw/HTM/product-marsC.htm#) which has a RS-232 > interface. According to the manual, > - the RS232 uses just the RX/TX pins > - it speaks MegaTec RUPS II > > I have installed nut-2.0.3 and using the fentonups driver, I get > most of the information OK: > [EMAIL PROTECTED] tmp]# upsc [EMAIL PROTECTED] > battery.charge: 100.0 > battery.voltage: 2.19 > driver.name: fentonups > driver.version: 2.0.3 > driver.version.internal: 1.22 > input.frequency: 50.0 > input.voltage: 225.3 > output.voltage: 220.0 > ups.load: 007 > ups.mfr: Ablerex > ups.model: PowerPure S3000RT > ups.status: OL > ups.temperature: 39.9 > > However, there are two values which are not OK: battery.charge: > 100.0 and battery.voltage: 2.19. The 100.0 value was shown even > immediately after a complete drain of the UPS. About 2 hours later the > software included in the package ("UPSilon 2000") claimed the battery > was charged 89% (increased to 95% half an hour later), value which is > much closer to reality then the 100% shown by nut. After an hour of > google and reading of the online nut docs I have no clue how to convince > nut to show the real values. Could anyone please assist me ? > > -- > Manuel Wolfshant linux registered user #131416 > IT manager NoBug Consulting Romania > http://www.brainbench.com/transcript.jsp?pid=40317 > > > > > _______________________________________________ > Nut-upsuser mailing list > [email protected] > http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser > -- Carlos Rodrigues _______________________________________________ Nut-upsuser mailing list [email protected] http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
