Hi Kjell,
Thanks for the quick responce.
I have removed the baud_rate. My bcmxcp_usb is located in /opt/bin.
(structure of the QNAP device).
The QNAP does not have a root user but an admin user so I ran the command
with -u admin.
Running the command I got the same output i think.
======================================================
[/opt/bin] # bcmxcp_usb -DD -a PowerWare -u admin
Network UPS Tools - BCMXCP UPS driver 0.21 (2.4.1)
USB communication subdriver 0.17
debug level is '2'
Communications with UPS lost: Receive error (data): got 33 bytes instead of
116!!!
Communications with UPS lost: Receive error (Request command): COMMAND: 31
RECONNECT USB DEVICE
Can't set POWERWARE USB configuration
Unable to find POWERWARE UPS device on USB bus
Things to try:
- Connect UPS device to USB bus
- Run this driver as another user (upsdrvctl -u or 'user=...' in ups.conf).
See upsdrvctl(8) and ups.conf(5).
Fatal error: unusable configuration
CLOSING
======================================================
Hopefully this might still be useful.
Thanks for you help,
Greg
--------------------------------------------------
From: "Kjell Claesson" <[email protected]>
Sent: Friday, April 17, 2009 1:58 AM
To: <[email protected]>
Cc: "Greg" <[email protected]>
Subject: Re: [Nut-upsuser] Nut and PowerWare 5115
torsdag 16 april 2009 02:25:58 skrev Greg:
Hi everyone,
Hi Greg,
Been searching like crazy to find an answer to this. I have even read
some
of the source code but cannot figure this one out.
I have installed nut 2.4.1 on my QNAP 409 Pro. (command: ipkg install
nut)
I have configured the ups.conf, upsd.conf and upsd.users.
When i run "upsdrvctl start" I get the following error messages and
output.
====================================================================
Network UPS Tools - UPS driver controller 2.4.1
Network UPS Tools - BCMXCP UPS driver 0.21 (2.4.1)
USB communication subdriver 0.17
Communications with UPS lost: Receive error (data): got 33 bytes instead
of
116!!!
Communications with UPS lost: Receive error (Request command): COMMAND:
31
RECONNECT USB DEVICE
Can't set POWERWARE USB configuration
Unable to find POWERWARE UPS device on USB bus
This looks like a access rights problem.
Can you try the following. Start the driver in debug mode like this.
/path/to/bcmxcp_usb -DD -a PowerWare -u root
Normal the path is /lib/nut but check where the bcmxcp_usb is located.
This should spit out some debug info. Stop it by hitting ctrl-c.
Send me (and the list) the output.
8<-------------------------snip--------------------------------
My ups.conf looks like this
user=admin
[PowerWare]
driver = bcmxcp_usb
port = auto
desc = "PowerWare 5115 UPS"
#pollinterval=1
baud_rate = 9600
You can remove the baud_rate. It is only for the serial part of the
driver.
Regards
Kjell (Driver author)
_______________________________________________
Nut-upsuser mailing list
[email protected]
http://lists.alioth.debian.org/mailman/listinfo/nut-upsuser
