Hmmm. Would Karlnet allow me to run an open AP with an RG-1000 and a 200mw card?
----- Original Message ----- From: "Ben Serebin" <[EMAIL PROTECTED]> To: "Terry Ewing" <[EMAIL PROTECTED]> Cc: <[EMAIL PROTECTED]> Sent: Wednesday, October 02, 2002 2:16 PM Subject: Re: [nycwireless] RG1000 Questions ... > Hello Terry and all, > > I doubt you can put any card (besides ORiNOCO cards [Gold, Silver, > Bronze]) in a stock RG-1000. I had upgraded the firmware to Karlnet SE-4500, > that's probably why it was able to handle the Prism based card (Senao > 200mW). Also, the range varies on the card in the RG. My setup is for a > point to point link since I'm trying to prevent any future signal > interference. > > Also, ORiNOCO cards are also called Avaya, Lucent, Agere, and a > couple of ones. It's just a different label.. > > -Ben > > > ----- Original Message ----- > From: "Terry Ewing" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Wednesday, October 02, 2002 1:53 PM > Subject: Re: [nycwireless] RG1000 Questions ... > > > > I saw a little while back that someone put a 200mw card into an rg-1000. > > Can you put any ol' 802.11b card in there? I thought these APs were > > specific to the Lucent Orinoco cards. > > > > Did the range improve significantly? > > > > -- > > NYCwireless - http://www.nycwireless.net/ > > Un/Subscribe: http://lists.nycwireless.net/mailman/listinfo/nycwireless/ > > Archives: http://lists.nycwireless.net/pipermail/nycwireless/ > > > > -- > NYCwireless - http://www.nycwireless.net/ > Un/Subscribe: http://lists.nycwireless.net/mailman/listinfo/nycwireless/ > Archives: http://lists.nycwireless.net/pipermail/nycwireless/ > -- NYCwireless - http://www.nycwireless.net/ Un/Subscribe: http://lists.nycwireless.net/mailman/listinfo/nycwireless/ Archives: http://lists.nycwireless.net/pipermail/nycwireless/
