Sorry a little bit OT: I'm trying to build a simple and cheap pci board with a low cost fpga like the machxo2 from lattice. Now I'm having some hard time to figure out if this device is compatible with 5 Volt pci or not. From the datasheet I understand that is compatible only with the 3.3 Volt implementation... But it looks like that specs are there to be broken, and a lot of people (also lattice: check "latticeXP2 advanced evaluation board") are just using those device on 5 Volt pci without a level shifter or something similar.
I'm a little bit confused. Any hint? Thank you Michele Carla' _______________________________________________ Open-graphics mailing list [email protected] http://lists.duskglow.com/mailman/listinfo/open-graphics List service provided by Duskglow Consulting, LLC (www.duskglow.com)
