Hi Tobias, You ranges look sensible (and work from me on a PX1000 with CX700M(2)). This is a shot in the dark by have you tried adding:
Option "VBEModes" "true" to Section "Device" This is documented as preventing a similar black screen on DVI output. Barnaby Tobias Ceglarek wrote: > Hello again, > >> Either manually set proper values for your monitor > > I am not an expert in configuring X, but I have tried out to manually > set the values by adding > > HorizSync 30-80 > VertRefresh 30-100 > > in the xorg.conf. Then the output is a little bit different (without the > message "vrefresh out of range"): > > ... > (II) CHROME(0): monitor0: Using default hsync range of 30.00-80.00 kHz > (II) CHROME(0): monitor0: Using default vrefresh range of 30.00-100.00 > Hz > (II) CHROME(0): Clock range: 20.00 to 230.00 MHz > (II) CHROME(0): ViaValidMode: Validating 640x350 (31500) > (II) CHROME(0): ViaModePrimaryVGAValid > (II) CHROME(0): Not using default mode "320x175" (bad mode > clock/interlace/doublescan) > ... > This is certanly needed for DVI output. > But below there is "hsync out of range" anymore. > > Which ranges are needed by openchrome? > >> or fix the conf to allow the monitor to send its EDID. > > How can I do this? > > Regards, > > TC > > _______________________________________________ openchrome-users mailing list [email protected] http://wiki.openchrome.org/mailman/listinfo/openchrome-users Main page: http://www.openchrome.org Wiki: http://wiki.openchrome.org User Forum: http://wiki.openchrome.org/tikiwiki/tiki-view_forum.php?forumId=1
